|
Frequently Asked Questions: PSC /
Percon Products
QS200
- How can I program my
scanner using bar codes?
Which interfaces
are supported by QS200?
Which bar code
symbologies will my scanner read, and how can I enable or disable a
specific symbology?
How do I add a
Carriage Return ("Enter") as a suffix to the data being
scanned?
How do I expand
UPC-E to UPC-A format?
Can I disable
the first and/or last digits of a UPC/EAN bar code?
1. How can I program my scanner using bar codes?
Programming your QS200 scanner is
easy with the Bar-Code Programming Menu. The Flow Chart section of the
programming menu provides a visual path to follow along with the
required bar codes to configure your scanner's interface, symbologies,
and operation parameters. Programming changes are stored in non-volatile
RAM which can retain the settings after power is turned off.
Reference: Bar-Code Programming Menu shipped with scanner.
2. Which interfaces are supported by QS200?
QS200 supports the following
interfaces:
- Keyboard Wedge
- OCIA
- RS232
- Wand Emulation
Reference: Bar-Code Programming Menu shipped with scanner.
3. Which bar code symbologies will my scanner read,
and how can I enable or disable a specific symbology?
QS200 supports the following
symbologies:
- UPC/EAN
- Code 39
- Interleaved 2 of 5
- Standard 2 of 5
- Matrix 2 of 5 C
- hinese Postal 2 of 5
- Codabar
- MSI/Plessey
See the Bar-Code Programming Menu for the
bar codes required to enable or disable specific symbologies.
Reference: Bar-Code Programming Menu shipped with scanner.
4. How do I add a Carriage Return ("Enter")
as a suffix to the data being scanned?
The bar code labels required to
perform this task are available in the General Parameters, TERMINATOR
section of the Bar-Code Programming Menu.
Reference: Bar-Code Programming Menu shipped with scanner
5. How do I expand UPC-E to UPC-A format?
The bar code labels required to
expand the UPC-E to UPC-A format are available in the above programming
guide under UPC-A/UPC-E, UPC-E.
Reference: Bar-Code Programming Menu shipped with scanner
6. Can I disable the first and/or last digits of a
UPC/EAN bar code?
Yes. Locate the symbology your
scanner is reading in the programming menu. To disable the first digit
(NSD or Number System Digit) scan the TRUNCATE LEADING DIGIT label. To
disable the last digit (Check Digit) scan the appropriate TRANSMIT CHECK
DIGIT bar code.
Reference: Bar-Code Programming Menu shipped with scanner
Tech Support :
973-579-0103 or 973-579-1309
Fax : 973-579-7564
8:30 to 5:00 Eastern Time. Mon.- Fri.
Return to the
Instruments & Equipment Home Page
TO SPEAK TO AN I&E
ACCOUNT REPRESENTATIVE PLEASE CALL
1-800-432-1255 or 1-973-579-0009
|
